Preparação e aplicação de óxidos tipo perovskita La1-xCexNiO3 e La1-xCaxNiO3 para obtenção de gás de síntese a partir do metano.

• Ano de defesa: 2006
• Autor(a) principal: Lima, Sania Maria de
• Orientador(a): Assaf, José Mansur
• Tipo de documento: Tese
• Tipo de acesso: Acesso aberto
• Idioma: por
• Instituição de defesa: Universidade Federal de São Carlos
• Programa de Pós-Graduação: Programa de Pós-Graduação em Engenharia Química - PPGEQ
• País: BR
• Palavras-chave em Português: Catálise; Oxidação parcial do metano; Reforma do metano com CO2; Perovskita
• Área do conhecimento CNPq: ENGENHARIAS::ENGENHARIA QUIMICA
• Link de acesso: https://repositorio.ufscar.br/handle/ufscar/3842

Catalysts precursors with perovskite structure like La1-xCexNiO3 ( x = 0, 0.03, 0.05, 0.1, 0.4 ,0.7) and La1-xCaxNiO3 (x = 0, 0.05, 0.1, 0.3, 0.5, 0.8) have been prepared by three different methods: precipitation, citrate and citrate with successive additions. The loss of mass and structure transformations during the calcination were studied by thermogravimetric and thermodifferential analysis; the calcined samples were characterized by X-ray diffraction, specific surface area measurements (BET method), temperature-programmed reduction, thermogravimetric analysis in H2 atmosphere, temperature-programmed desorption of oxygen, X-ray photoelectron spectroscopy and sequential pulse experiments with CH4/O2/CH4. The catalysts were tested in CO2 reforming and partial oxidation of methane. After the tests, the catalysts surface was studied by scanning electron microscopy and thermogravimetric analysis in oxidant atmosphere. Small quantities of NiO were observed together the perovskite structure even for x = 0 in the solids prepared by all the synthesis methods. In the Ce-La series with x ≥ 0.05 were also identified CeO2 and La2NiO4; the perovskite structure formation for x = 0.7 was not observed. For the samples containing Ca with x ≥ 0.1, in addition to the perovskite structure, was observed NiO and La2NiO4; when x ≥ 0.3 an additional CaO phase was identified. However, in these samples, the perovskite structure was still observed even with high Ca contents. The reaction results of CO2 reforming of methane showed that the Cecatalysts prepared by citrate route presented Ni particles smaller and with better dispersion than the catalysts obtained by precipitation. This was evidenced by the higher resistance to carbon formation. Among these catalysts, the La0.95Ce0.05NiO3 was the most promising because it was the most active and resistant to carbon formation. This carbon deposition resistance was due to the predominance of perovskite structure that resulted in higher dispersion of nickel particles and also to the presence of the incorporated cerium that increased its stability. The Ce containing catalysts obtained by the two citrate methods deactivated during the partial oxidation of methane due to the oxidation of active Ni fractions. These oxide sites favored the CO2 formation via the combustion of methane reaction. In the other hand, the catalysts obtained by precipitation were highly active to CO formation, and the most promising were those with x = 0 and x = 0.05. The Ca content influenced the carbon deposition resistance and the conversion levels in the CO2 reforming of methane. In partial oxidation of methane, for some contents of calcium, the reactants conversion levels have decreased due to the oxidation of active Ni fractions, but there was no carbon formation for all the catalysts.