Estudo teórico e experimental de um chiller a adsorção para sistemas de ar condicionado solar

• Ano de defesa: 2016
• Autor(a) principal: Vodianitskaia, Paulo José
• Tipo de documento: Tese
• Tipo de acesso: Acesso aberto
• Idioma: por
• Instituição de defesa: Universidade Federal da Paraíba; Brasil; Engenharia Mecânica; Programa de Pós-Graduação em Engenharia Mecânica; UFPB
• Palavras-chave em Português: Refrigeração; Adsorção; Ar condicionado; Modelagem; Difusão; Energia solar; Refrigeration; Adsorption; Air conditioning; Modeling; Diffusion; Solar energy; ENGENHARIAS::ENGENHARIA MECANICA
• Link de acesso: https://repositorio.ufpb.br/jspui/handle/tede/8957

Human society in general, and Brazil in particular, face severe scenarios, from restricted energy supply to climate change and other challenges for a sustainable future. Thus renewable energy alternatives offering lower environmental and social impacts such as solar energy are subjects of special interest. The present work refers to this challenging picture. As a way to apply renewable energy, solid adsorption air conditioning favors energy security and contributes to the mitigation of greenhouse gases due to the lower dependency in regard to primary energy. It allows to a reduction on demand peaks, and to a natural adjustment between supply and demand levels. Moreover, the materials used in such systems present low environmental impact, especially the refrigerant fluid: water, abundant in nature and non-toxic. The general objective of this work is the development of an experimental chiller using local technology, resulting in a state-of-the-art performance level. Specific objectives include the development of a representative model for the adsorber, the comparison of adsorption kinetics between two fractions of silica gel, the evaluate how specific heat and mass diffusion influence the chiller performance. The numerical model contributions are related to the use of specific heat of the adsorbed phase, and mass diffusion for cycle characterization. The model resulted representative of the experimental behavior. COP was found to be 0,53 and SCP is 68 W/kg for 2.0 mm beads. These values are comparable or higher to the ones reported in literature for silica gel in loose grains. The use of a crushed silica gel of smaller size (026 mm) resulted in lower level of performance, which is probably due to the reduction of porosity after crushing.