Compósito de matriz polimérica com carga de resíduos de manufatura do MDF (Midium Density Fiberboard)

• Ano de defesa: 2015
• Autor(a) principal: Gomes, Jailton Weber
• Tipo de documento: Tese
• Tipo de acesso: Acesso aberto
• Idioma: por
• Instituição de defesa: Brasil; UFRN; PROGRAMA DE PÓS-GRADUAÇÃO EM ENGENHARIA MECÂNICA
• Palavras-chave em Português: Compósitos poliméricos; Resíduo; MDF; Resinas poliéster ortoftálica e teraftálica; Forno solar; CNPQ::ENGENHARIAS::ENGENHARIA MECANICA
• Link de acesso: https://repositorio.ufrn.br/jspui/handle/123456789/23009

Countless studies related to improving the efficiency of production processes, in all sectors, had simple solutions to reduce production costs by reducing the raw material used in the manufacture of consumer goods. The ecological appeal is one of the main reasons that drive the use of industrial waste, however the reduction in the number of employed matrix composite and consequently lower production expense is an important aspect to be considered. This paper proposes the use of MDF waste (Miduim Density Fiberboard) collected powder in joinery, as reinforcement / cargo in the manufacture of polymer composites using as matrix resins orthophthalic polyester and tereftálica. The processes for obtaining composite and its characterization were studied by means of mechanical, thermal and physical properties of composite samples with mass fractions of 0, 10, 15 and 20% residue added to said resins. With the proposed material manufactured to a solar furnace type box with E20 composite. This composite enabled the use of lower resin reducing the manufacturing cost of the equipment. The average of the density values was 1.23 g / cm 3 having a standard deviation on the order of 0.015 g / cm3. The results obtained show that the composites with 59% maximum variation in tensile strength and flexural strength 57% lower than the matrix not precluding its use in applications with reduced mechanical stresses. In terms of heat resistance proposed composite showed advantages compared to the matrices of origin, orthophthalic resin and tereftálica. The study indicated that the resin waste aggregates have load function, however, there was an increase in modulus for all the manufactured composites and composite modulus of elasticity E20 showed 2.3 times higher than the tereftálica resin. The oven is manufactured with the E20 formulation proved to be competitive compared to other furnaces already tested in LMHES relative to the baking times of foods tested, obtaining temperatures in the absorber and the internal air of 133 ° C and 100 ° C respectively.